How To Remove Wall Tiles

 

You will need:

  • Club hammer
  • Wide-bladed cold chisel
  • Scraper
  • Dust mask
  • Goggles
  • Heavy-duty riggers gloves
  • Old blankets or sheets
  • Rubble sacks
  • Plaster filler

Step One: Clean And Protect Nearby Surfaces Clear the room as far as possible and cover vulnerable surfaces such as expensive worktops with old blankets as chips of tile will scratch the surface.

Step Two: Remove The Tiles Starting at the edge of the tiling or along a grout line, hammer the cold chisel under the first tile, levering it upwards as you work. Work across the wall, levering off sections of tile and collecting the pieces into rubble sacks as you work. Make sure the floor is well protected, as small pieces of tile can be ground into the surface.

Step Three: Scrape Off The Old Grout And Adhesive Once all the tiles are removed, use a scraper or the chisel to chip off any remaining grout or old adhesive. If any plaster has become loose, chip this way and fill the hole with plaster filler. You many need to use two layers to build up the thickness. If you have stud walls the plasterboard wall can be damaged as you remove the tiles. It may be easier to lever remove the entire plasterboard panel(s) and replace with new board before redecorating.

Step Four: Replacing Single Tiles It’s possible to replace just a few cracked or chipped tiles. Drill three or four holes close together in a vertical line across the damaged tile and use a cold chisel and hammer to break it into pieces, working from the line of holes. Lever the loose pieces away from the wall and clean off any loose grout around the edges with the cold chisel or a craft knife. If any of the wall plaster has come away with the tile, fill the hole with a plaster filler and leave to set. Spread some tile adhesive onto the back of the new tile, press it into the gap and check it’s flush with the other tiles by holding a straight edge e.g. a timber batten, across the surface. Regrout around the tile with a squeegee or sponge and clean off the excess before it hardens.

4 Responses to How To Remove Wall Tiles

  1. TheDuke says:

    Thanks I have been searching everywhere for this

  2. AussieJames says:

    This is really useful

  3. AussieJames says:

    The force is strong with this one

  4. DIYmum says:

    Great Do it yourself projects site!

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>